CALL US TODAY!

(800) 735-1268
DRYAIR STEAM & HOT WATER SYSTEMS

Steam Plate Heat Exchanger

This system transfers heat from "on-site" steam to a circuit of heat-transfer-fluid that enables the use of any of the DRYAIR accessories for heat distribution.  Using an existing steam source could prove to be the most versatile and economical approach to delivering temporary heat on a construction site / building renovation.  One unit will provide enough heating capacity to heat up to 50,000 square feet.

Specifications:

Steam Requirements

  • For use with low pressure steam (15 psi or less)
  • Steam supply and condensate return pipe connections to unit are 1.5" FNPT
  • Condensate trap is an integral part of the unit
  • Must be connected to the site supply by a licensed steam-fitter/pipe-fitter
  • Steam pressure reducing valves not included

 

Fluid Distribution

  • 2nd circuit - heat transfer fluid circuit
  • 2" hose and Kamlock connections
  • Reservoir On-board "open ventilated" glycol reservoir external connection for an optional external extended reservoir.  A selector valve is used to select either the on-board reservoir or external reservoir
  • Pump - 2HP, 28SFLA, 13FLA & 50-75 US GPM

 

Electrical

  • System requirements - 230V, 1ph, 60Hz, 30A
  • Control circuitry - 24V

 

Heat Exchanger

  • Copper-brazed stainless steel plates
  • Heat exchange *1000 kBtu/h (*w/ 1,036 lb/h of steam and 50 US GPM of fluid flow)